How many millibyte in 1 nibble? The answer is 500. We assume you are converting between millibyte and nibble. You can view more details on each measurement unit: millibyte or nibble The main non-SI unit for computer data storage is the byte. 1 byte is equal to 1000 millibyte, or 2 nibble. Note that rounding errors may occur, so always check the results. Use this page to learn how to convert between millibytes and nibbles. Type in your own numbers in the form to convert the units!
1 millibyte to nibble = 0.002 nibble
10 millibyte to nibble = 0.02 nibble
50 millibyte to nibble = 0.1 nibble
100 millibyte to nibble = 0.2 nibble
200 millibyte to nibble = 0.4 nibble
500 millibyte to nibble = 1 nibble
1000 millibyte to nibble = 2 nibble
You can do the reverse unit conversion from nibble to millibyte, or enter any two units below:
The SI prefix "milli" represents a factor of 10-3, or in exponential notation, 1E-3.
So 1 millibyte = 10-3 bytes.
The definition of a byte is as follows:
A byte is the basic unit of measurement of information storage in computer science. In many computer architectures it is a unit of memory addressing, consisting of 8 bits.
Since computer memory comes in base two rather than 10, a large portion of the software and computer industry use binary estimates of the SI-prefixed quantities, while producers of computer storage devices prefer the SI values. This is why a computer hard drive advertised with a "100 GB" decimal storage capacity actually contains no more than 93 GB of 8-bit (power of 2) addressable storage.
A nibble (often, nybble) is the computing term for a four-bit aggregation, or half an octet (an octet being an 8-bit byte). As a nibble contains 4 bits, there are sixteen possible values, so a nibble corresponds to a single hexadecimal digit (thus, it is often referred to as a "hex digit" or "hexit").
ConvertUnits.com provides an online conversion calculator for all types of measurement units. You can find metric conversion tables for SI units, as well as English units, currency, and other data. Type in unit symbols, abbreviations, or full names for units of length, area, mass, pressure, and other types. Examples include mm, inch, 70 kg, 150 lbs, US fluid ounce, 6'3", 10 stone 4, cubic cm, metres squared, grams, moles, feet per second, and many more!